EG Transport
FleetView - Stop paying for empty kilometres
FleetView adds a map-first control layer to your TMS so planners see idle trailers, answer ETA calls in seconds and manage subcontractor fleets with the same clarity as their own.
Cold Chain & Compliance Assurance
Get instant alerts on temperature, doors, and route changes so you can act before cargo or SLAs are at risk.
End-to-End Visibility
Track every vehicle, trailer, and shipment in one live map, eliminate blind spots.
Maximise Fleet Utilisation
Live view of all trailers and their movements lets you spot idle assets fast and turn wasted kilometres into paying kilometres.
Ready to see every trailer, live?
While your team chases updates, your customer hears the delay first. In our demo, you’ll see every trailer—owned or hired—on one live map, idle units reassigned before they roll empty, and delays handled automatically.
Take control before the next delay hits.
Ready to see every trailer, live?
While your team chases updates, your customer hears the delay first. In our demo, you’ll see every trailer—owned or hired—on one live map, idle units reassigned before they roll empty, and delays handled automatically.
Take control before the next delay hits.
One screen, total fleet and transport control
Fewer empty kilometres, no blind spots, and planners who spend their day optimising routes instead of chasing updates.
FleetView fuses live telematics from every trailer with the trip data already inside your TMS. Owned assets and subcontracted units appear side-by-side, colour-coded, filtered based on-time status.
The deviation engine quietly fades loads that are running to plan and throws instant alerts on the handful that threaten margin or customer service.
Cut empty kilometres, boost asset yield
Every trailer’s current and future location in one view, so no truck rolls empty.
FleetView merges live GPS-telematics with your TMS data to show every available trailer across all depots. The Time Machine glance projects where each unit will finish next, keeping ETA info fresh and preventing duplicate runs. Planners finally have the whole picture and can assign loads with confidence, turning idle kilometres into revenue kilometres.
Pickup, dock, delivery. Notified the moment it happens
The instant a load changes status, the whole chain—planners, terminals, customers—hears the same single truth.
When a trailer hits a gate, clears a dock, or signs off delivery, FleetView’s live geofence signal meets the driver’s update. One real-time message then ripples out automatically to every person who needs it. No calls, no guessing—just a network that stays perfectly in step and a planner who’s always one move ahead.
Cold-chain & high-value cargo. Protected in real time
Live temperature, door-open, and route-deviation alerts give planners the few critical minutes needed to save a load—or a reputation.
Temperature sensors and door telematics stream into FleetView every few seconds. Match those readings to the planned route and customer specs. If a reefer drifts two degrees, a door stays ajar, or a high-value trailer strays off course, an instant alarm reaches the planner with location, countdown, and next-best action.
Most issues are fixed before the product leaves tolerance, compliance logs are automatically stamped, and your customers see proof that their pharma, frozen food, or electronics are safe.
Route planner - every ferry, toll and CO₂ factor count
Plan ad-hoc runs in seconds with full trip cost, bridge and ferry fees, and certified CO₂ output, powered by PTV Route Optimizer.
FleetView’s built-in calculator pulls live tariffs from Color Line, Scandlines, Øresund, Storebælt and every major toll road, then blends them with PTV’s truck- and trailer-specific routing logic.
One click shows fastest vs. cheapest options, complete with kilometres and sailing hours impact and exhaust-standard CO₂ emissions. No spreadsheets, no surprises just a precise cost-and-carbon picture before you dispatch.
Subscribe to our newsletter
